BH FITNESS T1 BASIC Guía de usuario descargar pdf (Pagina 32)

Step 3 - Basic Scan Emulator Troubleshooting

•

List of Emulators User Guide

Step 3 - Basic Scan

At this point you have been able to determine that the emulator is powered and has

enumerated with Windows correctly and you are ready to perform a basic scan. The

basic scan is a standalone test and does not use CCSetup information or require that

CCStudio is installed or running.

This test assumes that you have passed the pervious steps and have the emulator

connected to your target board and the target board is powered.

The following section explains the confidence tests that can be executed to verify an

emulator is operational and can communicate to the target board (i.e. scan data through

the scan chain). This section does not utilize CCStudio and runs from the command line

independently, so we can determine if there is a possible problem with the emulator or

target board.

TIP: If Code Composer is running or is not responding, close all running processes (i.e

cc_app, cc_setup) associated with Code Composer before proceeding. You can

do this from the Windows task manager(usually invoked by CTRL+ALT+DEL).

TIP: The following tests the scan chain which includes the target. It is recommended that

you connect the JTAG cable to the target board and reset the target prior to

running these tests.

XDSPROBE

Blackhawk Emulators

Go to folder \CCStudio\blackhawk\utility\BHProbe.2\

and run the corresponding BATCH file

for your emulator model. Please refer to the table below and to the BHProbe documentation located in

the same folder for more details.

The output log files are placed in the log subfolder (i.e. BHProbe.2\log).

\CCStudio\blackhawk\utility\BHProbe.1 on older driver installations

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 66 67

Sin comentarios

BH FITNESS T1 BASIC Guía de usuario Pagina 32