BH FITNESS T1 BASIC Guía de usuario descargar pdf (Pagina 13)

Emulator Troubleshooting Step 2 - Enumeration

User Guide List of Emulators

•

Step 2 - Enumeration

The following section will help you identify that the emulator has enumerated

successfully. By enumerated, we mean that Windows can see that the emulator has

been attached to the computer and has loaded the emulator’s device drivers

successfully.

If you are using the Ethernet connection to an emulator, and not USB or PCI (plug-n-play

interface), there are a couple of other steps necessary to identify that Windows has

loaded the emulator’s device drivers correctly.

Please locate your emulator model below to determine if it has enumerated

successfully.

A. Windows Device Manager

The Windows Device Manager can be used to determine USB and PCI emulator enumeration and

successful device driver installation. To view the device manager Go to Start Æ Run…Æ

Devmgmt.msc

Below are sample images of each emulator’s enumeration in the device manager. The following is an

example of a Blackhawk emulator (USB or PCI).

PCI510JTAGEmulator(BH‐PCI‐510)

Figure 8 BH-PCI-510 Device Manager Enumeration

PASS/FAIL

If the emulator is listed without any symbol (such as exclamation point or red ‘x’) on top of the

device, then it has properly enumerated and, go to the next step to verify that it is listed in the

Blackhawk Control Panel.

If there is a symbol (such as exclamation point or red ‘x’) on top of the device or it is not shown,

this means that there is partial or no enumeration of the device. Please report this information

(step that failed) to Blackhawk support and be sure to include the unit’s model and serial number.

There is no reason to continue with these procedures.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 66 67

Sin comentarios

BH FITNESS T1 BASIC Guía de usuario Pagina 13